Mediamorphy Guides

How to pull the audio out of a video (and which format to pick)

Published November 17, 2026

A recorded lecture you want to hear on the commute, a meeting you only need to listen back to, a performance you filmed for the sound. In each case the picture is dead weight: an hour of 1080p video runs to gigabytes, while the same hour of audio fits in tens of megabytes.

What extraction actually does

A video file holds two separate streams side by side: the picture and the sound. Extracting audio drops the picture stream and writes the sound into an audio file. No picture is processed, so it finishes far sooner than converting video does.

One thing to know: this converter re-encodes the sound into the format you choose instead of copying it bit for bit. For listening, the difference is inaudible at sensible settings. If you plan to edit the audio and export it again, choose a lossless format so you do not stack one lossy encode on another. The audio formats guide explains the families in detail.

Pick the format by what happens next

The format follows the destination.
You want toChooseWhy
Listen on a phone, in a car, anywhereMP3Plays on everything ever made
Keep it in an Apple libraryM4AAAC sounds slightly better than MP3 at the same bitrate
Edit it in an audio or video editorWAVUncompressed, so editing adds no further loss
Archive it at full quality in less spaceFLACLossless at roughly half the size of WAV

Why 320 kbps is usually wasted

The sound inside most videos is already compressed, typically AAC at somewhere between 128 and 192 kbps. Encoding that to a 320 kbps MP3 cannot restore detail that was discarded when the video was made. It only produces a bigger file with the same sound. A higher number feels safer, but the ceiling was set by the source.

  • Speech (lectures, meetings, interviews): 128 kbps is more than enough.
  • Music from a typical video: 192 kbps matches what the source can offer.
  • Music from a high quality source you recorded yourself: 256 or 320 kbps, or go lossless.

How big will the file be?

For MP3 and M4A, size depends only on bitrate and length, so it can be worked out in advance.

Bitrate × duration. WAV assumes 16-bit stereo at 48 kHz.
Setting10 minutes1 hour2 hours
128 kbps9.6 MB58 MB115 MB
192 kbps14.4 MB86 MB173 MB
256 kbps19.2 MB115 MB230 MB
320 kbps24 MB144 MB288 MB
WAV115 MB691 MB1.4 GB

The WAV row is the reason not to pick it by default. It is the right choice for editing and a poor one for a two-hour lecture you only want to hear once.

Doing it

  1. Open Video to Audio and add the video. It stays on your device; nothing is uploaded, which matters for recordings of meetings and classes.
  2. Choose the audio format. The converter notes that the video's audio track will be extracted.
  3. Set Bitrate using the list above.
  4. If you only need part of it, open Trim / cut and enter the start and end times.
  5. Convert and download.

Two problems people run into

The recording is too quiet. Lecture halls and meeting rooms produce quiet recordings. The Volume control amplifies above 100%. Raise it in modest steps, because pushing loud moments past the maximum makes them distort, and that cannot be undone afterwards.

The video is very large. The whole file is loaded into memory before the sound can be pulled out, so a multi-gigabyte recording may fail in a browser even though the audio you want is small. Recording at a lower resolution next time, or using a desktop tool for that one file, gets around it.

A last point that is easy to forget: extract audio only from recordings you made or have permission to use. A lecturer's or performer's rights do not disappear when the picture does.

Try it yourself

More guides